Network protocols
7.7 HTTPS server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
339
Call the command without parameters:
no ip http
HTTP is disabled on the device.
You can display the setting of this function and other information with the show ip http
server status
command.
You enable HTTP with the
ip http command.
This section describes commands of the Hypertext Transfer Protocol Secure (HTTPS).
show ip http secure server status
Description
This command shows the status of the HTTPS server.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show ip http secure server status
The status, cipher suite and version of the HTTPS server are displayed.