Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
301
This section describes commands of the Simple Network Management Protocol (SNMP).
This section describes commands with which you display various settings.
This command shows the status information of SNMP.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show snmp
The status information is displayed.
show snmp community
Description
This command shows the details of the configured of SNMP communities.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
