EasyManuals Logo

Siemens SCALANCE W760 Configuration Manual

Siemens SCALANCE W760
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #210 background imageLoading...
Page #210 background image
Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
210 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.2.3.4
switchport ingress-filter
Description
With incoming packets, the ingress filter checks whether the port on which the packet was
received belongs to the sending VLAN. If this is not the case, the packet is not processed.
With this command, you enable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
switchport ingress-filter
Result
The ingress filter is activated.
Further notes
You disable the filter with the no switchport ingress-filter command.
You can display the status of the ingress filter and other settings with the
show vlan port
config
command.
6.2.3.5
no switchport ingress-filter
Description
With this command, you disable the ingress filter.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#

Table of Contents

Other manuals for Siemens SCALANCE W760

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W760 and is the answer not in the manual?

Siemens SCALANCE W760 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W760
CategoryWireless Access Point
LanguageEnglish

Related product manuals