Siemens SCALANCE W760 Configuration Manual

Network protocols
7.2 DHCP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
277
7.2
DHCP client
This section describes commands of the Dynamic Host Configuration Protocol (DHCP).
7.2.1
show ip dhcp client stats
Description
With this command, you display the statistical counters of the DHCP client.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dhcp client stats
Result
The counters are displayed.
7.2.2
show ip dhcp client
Description
With this command, you display the configuration settings of the DHCP client.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dhcp client

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English