Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
286 Configuration Manual, 11/2014, C79000-G8976-C351-03
no ip dhcp-server icmp-probe
Note
The command is only available with
the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command, you disable the "Probe address with ICMP Echo before offer" function.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
no ip dhcp-server icmp-probe
The function is disabled.
You enable the function with the ip dhcp-server icmp-probe command.
To Next Page
Loading...
Need help?
General
