Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
269
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
You disable the DCP server with the no dcp server command.
no dcp server
Description
With this command, you disable the DCP server.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no dcp server
The DCP server is disabled.
You enable and configure the DCP server with the dcp server command.
To Next Page
Loading...
Need help?
General
