Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
351
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
You exit the NAT Configuration mode with the end or exit command.
Commands in the NAT configuration mode
This section describes commands that you can call up in the NAT Configuration mode.
In the Global Configuration mode, enter the
nat command to change to this mode.
● If you exit the NAT Configuration mode with the
exit command, you return to the Global
Configuration mode.
● If you exit the NAT Configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you configure the translation list for communication from the global to
the local network.
A maximum of 60 entries are possible.
Note
This command is only available in the client mode
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
To Next Page
Loading...
Need help?
General
