Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
144 Configuration Manual, 11/2014, C79000-G8976-C351-03
wlan alternative channel (access point)
Description
If you have activated the DFS function, you specify the alternative channel with this
command. If the access point on the current channel discovers a disruption, it switches to
the alternative channel.
Note
This command is available only in access point mode.
● The DFS function is enabled.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan alternative channel { show-channels | <number (0=auto)> }
The parameters have the following meaning:
Lists all available channels.
Number of the alternative channel
If you want the access point to
search for a free channel itself, use
Default value: 0 (AUTO)
The alternative channel is set.
You display the setting with the show wlan basic <wlan 0/X> command.
You enable the DFS function with the
wlan dfs command.
wlan dfs (Page 168)
To Next Page
Loading...
Need help?
General
