EasyManuals Logo

Siemens SCALANCE W760 Configuration Manual

Siemens SCALANCE W760
432 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #206 background imageLoading...
Page #206 background image
Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
206 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
base bridge-mode {dot1d-bridge|dot1q-vlan}
The parameters have the following meaning:
Parameter
Description
Range of values
dot1d-bridge
Sets the mode of the device to "transparent"
for the Spanning Tree protocol.
Default setting
dot1q-vlan
sets the mode of the device to "VLAN-aware"
for a virtual bridged LAN.
-
Result
The device mode is configured.
Further notes
You display the status of this function and other information with the show vlan device info
command.
6.2.2.6
mgmt vlan
Description
With this command, you change the agent VLAN ID. You can only use VLANs that have
already been configured.
Note
Changing the agent VLAN ID
If the configuration PC is connected directly to the device via Ethernet and you change the
agent VLAN ID, the device is no longer reachable via
Ethernet following the change.
Requirement
In "base bridge-mode", the mode for the device is set to dot1q-vlan
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#

Table of Contents

Other manuals for Siemens SCALANCE W760

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE W760 and is the answer not in the manual?

Siemens SCALANCE W760 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE W760
CategoryWireless Access Point
LanguageEnglish

Related product manuals