Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
61
With this command, you disable the sending and receipt of LLDP packets on the interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
no lldp{transmit|receive}
The parameters have the following meaning:
the sending of LLDP packets is enabled
the receipt of LLDP packets is disabled
Note
Disabling both options
When you call this command, you can only select one option.
you want to disable both options, call up the command again.
The setting is configured.
You enable the sending or receipt of LLDP packets with the lldp command.
You display the status of LLDP with the
show lldp status command.
To Next Page
Loading...
Need help?
General
