Siemens SCALANCE W760 - Vlan

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
204 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.2.2.3
vlan
Description
With this command, you create a VLAN on the device and change to the VLAN configuration
mode.
Note
The device supports up to 2 virtual
networks.
In the provider backbone bridge mode, this command is used to create user, service and
backbone VLANs.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Parameter
Description
Range of values
vlan-id
Number of the addressed VLAN
1 ... 4094
Do not enter any leading zeros with the number of the VLAN.
Result
The VLAN is created.
You are now in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Further notes
You delete the VLAN with the no vlan command.
You can display information about the VLAN with the
show vlan command.