Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
154 Configuration Manual, 11/2014, C79000-G8976-C351-03
You display the setting with the show wlan client <wlan 0/X> command.
You enable the function with the
wlan any ssid command (default setting).
wlan any ssid (Client) (Page 152)
wlan background scan interval (client)
Description
With this command, you specify the Interval at which the client scans for further access
points.
Note
This command is only available in the client mode.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call up the command with the following parameters:
wlan background scan interval <ms(300-60000)>
The parameter has the following meaning:
Values or range of values
Time in milliseconds (ms) 300 ... 60 000
The interval is specified.
You show the set interval with the show wlan client <wlan 0/X> command.
To Next Page
Loading...
Need help?
General
