Siemens SCALANCE W760 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
233
6.3.3.8
no spanning-tree l2t-edge
Description
With this command, you disable the setting that an end device may be located at a layer 2
tunnel port.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no spanning-tree l2t-edge
Result
The setting is disabled.
Further notes
The automatic discovery of a bridge on the interface is disabled with the spanning-tree l2t-
edge
command.
You can display the status of this function with the
show spanning-tree l2t-edgecommand.
6.3.3.9
spanning-tree mst configuration
Description
With this command, you change to the MSTP configuration mode.
Requirement
You are in the Global configuration mode.
● MSTP is enabled
● Base bridge mode: 802.1Q VLAN Bridge
● Compatibility mode: MSTP
The command prompt is as follows:
cli(config)#

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English