Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
275
Call up the command with the following parameters:
no ip address [{ <ucast_addr>}]
The parameter has the following meaning:
IP Address of the VLAN interface that will
enter a valid IP address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The assignment of the IP address to a VLAN interface is deleted and DHCP is disabled.
Note
Effectiveness of the command
The command is effective immediately.
If you configure the interface via which
you access the device, you can lose the connection!
You configure the setting with the ip address command.
You display this setting and other information with the
show ip interface command.
ip address dhcp
Description
With this command, the VLAN interface obtains the IP address via DHCP.
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Call the command without parameters:
ip address dhcp
To Next Page
Loading...
Need help?
General
