Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
311
no snmp access
Description
With this command, you delete the access to an SNMP group.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
snmp access <GroupName>{v1|v2c|v3{auth|noauth|priv}}
The parameters have the following meaning:
Name of the group to which access is
max. 32 characters
Version Selects the version of the protocol
used
•
v1
•
v2c
•
Authentication Selects the authentication method:
•
auth
•
noauth
•
The access to an SNMP group is deleted.
You configure the setting with the snmp access command.
You display the configured SNMP groups with the
show snmp group command.
You display the access configurations for SNMP groups with the
show snmp group access
command.
You display the configured SNMP tree views with the
show snmp viewtree command.
To Next Page
Loading...
Need help?
General
