Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
251
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
several properties, call the command several times.
The selected setting is reset to the default value.
You configure the setting with the spanning-tree mst command (properties).
You display these settings and other information with the commands that start with
show
spanning tree ...
.
spanning-tree mst hello-time
Description
With this command, you configure the Hello time after which the bridge sends its
configuration frames (BPDUs).
A change to this value applies to all MST instances active on this interface.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree mst hello-time <seconds(1-2)>
The parameter has the following meaning:
Time after which the bridge sends its
configuration frames (BPDUs)
1 ... 2
To Next Page
Loading...
Need help?
General
