Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
189
The function is enabled.
You display the setting with the show wlan vap <vap X 0/Y>command.
You disable the function with the
no vap broadcast ssid command.
no vap broadcast ssid (access point) (Page 189)
no vap broadcast ssid (access point)
Description
With this command, you disable the "Broadcast SSID" function. The SSID is no longer sent
in the frame of the access point. This means that the SSID is not visible for other devices.
Only stations that know the SSID of the access point and that are configured with it can
connect to the access point. The "Any SSID" option must be disabled on these clients.
available only in access point mode.
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
no vap broadcast ssid
The function is disabled.
You display the setting with the show wlan vap <vap X 0/Y>command.
You enable the function with the
vap broadcast ssid command (default setting).
To Next Page
Loading...
Need help?
General
