Diagnostics
11.1 Diagnostics
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
420 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
no severity { mail | log | syslog }
The parameters have the following meaning:
The setting of the threshold value for
sending system event messages by e-
-
The setting of the threshold value for
entering system event messages in the
-
The setting of the threshold value the
entering event messages in the Syslog
-
If you do not select any parameters from the parameter list, the default value is used.
The settings for sending system event messages are configured.
You enable the setting with the severity command.
You display the status of this function and other information
show events severity.
With this command, you configure and enable the monitoring of the physical network
connections for cable breaks or for pulling of the connector.
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
To Next Page
Loading...
Need help?
General
