Siemens SCALANCE W760 - Vap Security Default-Key (Access Point)

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
390 Configuration Manual, 11/2014, C79000-G8976-C351-03
Result
The encryption method is configured.
Further notes
You display the settings with the show wlan security <vapX 0/Y> command.
10.2.6.3
vap security default-key (access point)
Description
With this command, you specify which WEP key from the key table is used for encryption.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Syntax
Call up the command with the following parameters:
vap security default-key <index (1-4)>
The parameter has the following meaning:
Parameters
Description
Values or range of values
index
Index of the key table
1...4
Result
The WEP key is specified.
Further notes
You display the settings with the show wlan security <vapX 0/Y> command.