Configuration
3.1 System
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
46 Configuration Manual, 11/2014, C79000-G8976-C351-03
You are prompted to enter the administrator password. After logging in successfully, you are
in the Privileged EXEC mode.
The command prompt is as follows:
cli#
With this command, you exit the Command Line Interface.
If you are connected to the device via telnet, the session is closed.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
logout
The CLI session is ended and the Windows Login prompt is displayed.
With this command, you request a response from a device in the network.
This allows you to check whether or not another node is reachable.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
