Siemens SCALANCE W760 - Show Wlan Client-List (Access Point)

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
124 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.1.1.9
show wlan client-list (access point)
Description
This command shows a table with the clients logged on with the access point as well as
additional information, for example status, signal strength, MAC address.
Note
The command is available only in
access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show wlan client-list [wlan 0/X [{mac <macaddr> | sys <sysname> | AID}]]
The parameter has the following meaning:
Parameter
Description
Values or range of val-
ues
wlan 0/X
WLAN interface
Enter a valid interface.
mac
Keyword for the MAC address of the client
-
macaddr
MAC address
aa:bb:cc:dd:ee:ff
sys
Keyword for the system name of the client
-
sysname
System name
AID
Connection ID of the client.
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The table with the logged-on clients is displayed.