Siemens SCALANCE W760 - Load and Save; Show Loadsave Files

Configuration
3.2 Load and Save
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
65
3.2
Load and Save
This section describes commands for displaying, copying, saving and downloading files for
the device.
Note
Note that during the installation of a previous version, the configuration data can be lost. In
this case, the device starts up with the
factory configuration settings after the firmware has
been installed.
3.2.1
show loadsave files
Description
This command shows the current Load&Save file information.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show loadsave files
Result
The current Load&Save file information is displayed.