Siemens SCALANCE W760 Configuration Manual

Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
196 Configuration Manual, 11/2014, C79000-G8976-C351-03
6.2
VLAN
This section describes commands for configuring and managing virtual networks (VLANs).
6.2.1
The "show" commands
This section describes commands with which you display various settings.
6.2.1.1
show dot1d mac-address-table
Description
This command shows the table with the static and dynamic unicast entries and the dynamic
multicast entries.
Requirement
● In "base bridge-mode", the mode for the device is set to "transparent".
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call up the command with the following parameters:
show dot1d mac-address-table [address<aa:bb:cc:dd:ee:ff>]
[interface{<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter
Description
Values
address
Keyword for a MAC address
-
aa:bb:cc:dd:ee:ff
MAC address -
interface
Keyword for a an interface description
-
interface-type Type or speed of the interface Enter a valid interface.
interface-id
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English