Functions specific to SCALANCE
4.4 iPCF-MC
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
97
iPCF-MC is disabled.
You enable iPCF-MC with the wlan ipcf-mc command.
You display the setting with the
show wlan ipcf-mc command.
wlan ipcf-mc cycle-time (access point)
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command, you configure the cycle time for iPCF-MC.
You are in the WLAN configuration mode.
The command prompt is as follows:
cli(config-wlan)#
Call up the command with the following parameters:
wlan ipcf-mc cycle-time <ms (32-512)>
The parameter has the following meaning:
Values or range of values
Cycle time in millisec-
32 ... 512
The cycle time is configured.
You display the setting with the show wlan ipcf-mc command.
To Next Page
Loading...
Need help?
General
