Siemens SCALANCE W760 - 8 Load Control; Dynamic MAC Aging; Show Mac-Address-Table Aging-Time

SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
345
Load control
8
This part contains the sections describing the functions for controlling and balancing network
load.
8.1
Dynamic MAC aging
The section describes commands with which the aging of dynamically learned entries is
configured in a MAC address list.
8.1.1
show mac-address-table aging-time
Description
To ensure that the address entries are up-to-date, MAC addresses are only kept in the
address table for a specified time.
This command shows the time after which the MAC addresses are removed from the
address table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show mac-address-table aging-time
Result
The time is displayed.