Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
392 Configuration Manual, 11/2014, C79000-G8976-C351-03
no vap security encryption (access point)
Description
With this command, you disable encryption with a fixed (unchanging) WEP key. This setting
is activated as default. You can only enable or disable encryption if you have selected "Open
System" for authentication.
Note
This command is available only in access point mode.
● The type of authentication is "open-system".
You are in the Interface Configuration mode of the VAP interface.
The command prompt is as follows:
cli (config-if-vapX-0-Y)#
Call the command without parameter assignment:
no vap security encryption
The encryption is disabled.
You display the settings with the show wlan security <vapX 0/Y> command.
You enable the encryption with the
vap security encryption command.
vap security encryption (access point) (Page 391)
To Next Page
Loading...
Need help?
General
