Network protocols
7.1 IPv4 protocol
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
276 Configuration Manual, 11/2014, C79000-G8976-C351-03
The DHCP assigns the IP address to the VLAN interface.
You delete the settings with the no ip address command.
You display this setting and other information with the
show ip interface command.
dcp forwarding
Description
With this command, you configure the forwarding behavior of the interface for DCP frames.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
dcp forwarding {block|forward}
The parameters have the following meaning:
DCP frames are forwarded
The forwarding behavior of the interface for DCP frames is configured.
To Next Page
Loading...
Need help?
General
