Siemens SCALANCE W760 - Commands in the DHCPPOOL Configuration Mode; Lease-Time

Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
289
Result
The required IPv4 address band is deleted.
Further notes
You create the IPv4 address band with the ip dhcp-server pool command.
7.3.4
Commands in the DHCPPOOL configuration mode
This section describes commands that you can call up in the DHCPPOOL Configuration
mode.
In the Global Configuration mode, enter the
ip dhcp-server pool command to change to this
mode.
● If you exit the DHCPPOOL Configuration mode with the
exit command, you return to the
Global Configuration mode.
● If you exit the DHCPPOOL Configuration mode with the
end command, you return to the
Privileged EXEC mode.
7.3.4.1
lease-time
Note
The command is only
available with the following device:
•
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
Description
With this command, you specify how long the assigned IPv4 address remains valid. Once
this period has elapsed, the device must either request a new IPv4 address or extend the
lease time of the existing IPv4 address.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#