Layer 3 functions
9.1 NAT
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
355
nat interface (client)
Description
With this command, you enable NAT for the Ethernet interface.
Note
This command is only available in the client mode
You are now in the NAT Configuration mode.
The command prompt is as follows:
cli(config-nat)#
● "Own" is set for "MAC Mode".
Call up the command with the following parameters:
nat interface <interface-type><interface-id>}
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
NAT is activated for the Ethernet interface.
You disable NAT with the no nat interface command.
You configure the MAC mode with the
wlan client mac mode command.
You show the NAT configuration and the translation list with the
show nat command.
show nat (client) (Page 349)
To Next Page
Loading...
Need help?
General
