Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
148 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
wlan ampdu frames-limit <frames(2-64)>
The parameter has the following meaning:
Parameter
Description
Values or range of values
frames
Number of frames that are grouped to-
gether in one AMPDU data packet.
2...64
Default: 32
Result
The number of frames is specified.
Further notes
You display the setting with the show wlan advanced-11n <wlan 0/X> command.
6.1.5.9
wlan antenna additional-attenuation
Description
With this command, you specify the additional attenuation caused, for example by an
additional splitter. Using the
show wlan basic command, check whether or not the current
WLAN settings violate the permitted transmit power restrictions (
TX Power Check) of the
selected country.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan antenna additional-attenuation <index (1-X)> <dB(0-70)>
The parameters have the following meaning:
Parameter
Description
Values or range of values
index
Antenna connector X = 1
dB
Attenuation in decibels [dB] 0...70
Default: 0

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English