Siemens SCALANCE W760 - Commands in the WLAN Interface Configuration Mode

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
373
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator shared-secret <index(1-2)> <string>
The parameters have the following meaning:
Parameters
Description
Values or range of values
index
Index of the RADIUS server
1...2
string
Password Enter the password of the
RADIUS server.
Result
The password is configured.
Further notes
You display the setting with the show wlan security ap-radius-authenticator command.
See also
show wlan security ap-radius-authenticator (Access Point) (Page 361)
10.2.5
Commands in the WLAN Interface configuration mode
This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
interface wlan 0/X command to change to this
mode.
● If you exit the WLAN Interface Configuration mode with the
exit command, you return to
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
end command, you return to
the Privileged EXEC mode.