Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
136 Configuration Manual, 11/2014, C79000-G8976-C351-03
With this command, you change to the WLAN Configuration mode.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
wlan
You are in the WLAN Configuration mode.
The command prompt is as follows:
cli (config-wlan)#
You exit the particular WLAN Configuration mode with the end or exit command.
Commands in the WLAN configuration mode
This section describes commands that you can call up in the WLAN configuration mode.
In the Global Configuration mode, enter the
wlan command to change to this mode.
Commands relating to other topics that can be called in the WLAN configuration mode can
be found in the relevant sections.
● If you exit the WLAN configuration mode with the
exitcommand, you return to the Global
configuration mode.
● If you exit the WLAN Configuration mode with the
end command, you return to the
Privileged EXEC mode.
To Next Page
Loading...
Need help?
General
