Siemens SCALANCE W760 - Wlan Hw-Retries

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
177
Syntax
Call up the command with the following parameters:
wlan ht channel width { HT-20 | HT-40-UP | HT-40-DOWN }
The parameters have the following meaning:
Parameters
Description
HT-20
Channel bandwidth 20 MHz
HT-40-UP Channel bandwidth 40 MHz. The configured channel and the neighbor-
ing channel above it are used. (default setting)
HT-40-DOWN
Channel bandwidth 40 MHz. The configured channel and the underlying
neighboring channel are used.
Note
Channel bandwidth 40 MHz and frequency band 2.4 GHz
If the access
point detects another access point on the configured channel or on neighboring
channels, the access point changes the channel bandwidth from 40 MHz to 20 MHz. If you
set a "free" channel on the access point, the access point uses the channel bandwidth 40
M
Hz.
Result
The channel bandwidth is set.
Further notes
You display the setting with the show wlan ap <wlan 0/X> command.
6.1.5.41
wlan hw-retries
Description
With this command, you specify the number of retries. The hardware repetition is performed
by the WLAN chip itself when it tries to repeat an unacknowledged packet immediately.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#