Siemens SCALANCE W760 - Spanning-Tree Mst Instance-ID Root

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
234 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call the command without parameters:
spanning-tree mst configuration
Result
You are now in the MSTP configuration mode.
The command prompt is as follows:
cli(config-mst)#
Further notes
You exit the MSTP configuration mode with the end or exit command.
6.3.3.10
spanning-tree mst instance-id root
Description
With this command you specify whether the device is a root bridge (primary) or a substitute
root bridge (secondary).
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
spanning-tree mst{instance-id<instance-id(1-64)>}root{primary|secondary}
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Keyword for the instance
-
instance-id
Number of the instance 1 ... 64