Siemens SCALANCE W760 Configuration Manual

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
321
Parameter
Description
Range of values
volatile
nonvolatile
Specifies whether the settings re-
main following a restart:
•
volatile:
The default settings are used af-
ter a restart.
•
nonvolatile:
The saved settings are used af-
ter a restart.
port
Keyword for the port number at
which the SNMP manager receives
traps and inform messages
-
integer
Port number
1 ... 65535
For information on addresses and interfaces, refer to the section "Addresses and interface
names".
If optional parameters are not specified when configuring, the default values apply.
Result
The SNMP target address is configured.
Further notes
You delete the SNMP target address with the no snmp targetaddr command.
You display the SNMP target address with the
show snmp targetaddr command.
You configure the SNMP target parameters with the
snmp targetparams command.
You display the SNMP target parameters with the
show snmp targetparam command.
7.4.2.15
no snmp targetaddr
Description
With this command, you delete the SNMP target address.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English