Siemens SCALANCE W760 - Wlan Security Ap-Radius-Authenticator Max-Retransmit

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
366 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
wlan security ap-radius-authenticator address <index (1-2)> {ipv4 <ucast_addr> |
fqdn-name <FQDN (100)>}
The parameters have the following meaning:
Parameter
Description
Values or range of values
index
Index of the RADIUS server
1...2
ipv4
Keyword for an IPv4 address
-
ucast_addr
IPv4 address
Enter a valid IPv4 address.
fqdn-name
Keyword for a domain name -
FQDN
Domain name (Fully Qualified Domain Name)
Maximum of 100 characters
Result
The RADIUS server is enabled.
Further notes
You display the setting with the show wlan security ap-radius-authenticator command.
See also
show wlan security ap-radius-authenticator (Access Point) (Page 361)
10.2.4.4
wlan security ap-radius-authenticator max-retransmit
Description
With this command, you configure maximum number of attempts to establish a connection.
Note
This command is available only in access point mode.
Requirement
You are in the WLAN Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-wlan)#