Siemens SCALANCE W760 - No Spanning-Tree Priority

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
238 Configuration Manual, 11/2014, C79000-G8976-C351-03
Syntax
Call up the command with the following parameters:
spanning-tree[mst <instance-id(1-64)>] priority <value(0-61440)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
mst
Keyword for a Multiple Spanning Tree
instance
-
instance-id
Number of the instance 1 ... 64
priority
Keyword for the priority
-
value
Value for the priority 0 ... 61440
Default: 32768
You can only change the value for the priority in the steps of 4096.
Result
The priority of the device is configured.
Further notes
You can reset the setting to the default with the no spanning-tree priority command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
6.3.3.15
no spanning-tree priority
Description
With this command, you reset the priority of the device back to the default value.
The default value is 32768.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#