Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
134 Configuration Manual, 11/2014, C79000-G8976-C351-03
The parameter has the following meaning:
Values or range of values
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
The WDS partners of the WLAN interface are displayed.
show wlan ip-mapping
Description
This command shows the table for the IP mapping. The table contains the assignment of
MAC address and IP address of the devices for which the client makes WLAN access
possible.
Note
This page is only available for clients or access points in client mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show wlan ip-mapping
The IP mapping table is displayed.
To Next Page
Loading...
Need help?
General
