To Next Page

To Previous Page

Configuration

3.2 Load and Save

SCALANCE W760/W720 to IEEE 802.11n Command Line Interface

Configuration Manual, 11/2014, C79000-G8976-C351-03

Syntax

Call the command without parameters:

loadsave

Result

You are now in the LOADSAVE configuration mode.

The command prompt is as follows:

cli(config-loadsave)#

Further notes

You exit the LOADSAVE configuration mode with the exit command.

3.2.4

Commands in the LOADSAVE configuration mode

This section describes commands that you can call up in the LOADSAVE configuration

mode.

In the Global Configuration mode, enter the

loadsave command to change to this mode.

You display the valid file types for the commands in the LOADSAVE Configuration mode

with the global command

show loadsave tftp.

● If you exit the LOADSAVE configuration mode with the

exitcommand, you return to the

Global Configuration mode.

● If you exit the LOADSAVE configuration mode with the

end command, you return to the

Privileged EXEC mode.

3.2.4.1

delete

Description

With this command, you call up the possible files or delete a specific file.

Requirement

You are in the LOADSAVE configuration mode.

The command prompt is as follows:

cli(config-loadsave)#

Siemens SCALANCE W760 Configuration Manual

Other manuals for Siemens SCALANCE W760