Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
247
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
The parameters have the following meaning:
The transfer of BPDU packets is disa-
Default: disabled
The transfer of BPDU packets is ena-
bled for the port
-
The BPDU transmit status is configured.
spanning-tree bpdu-receive
Description
With this command, you enable or disable the BPDU receive status at the port.
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
spanning-tree bpdu-receive{enabled|disabled}
The parameters have the following meaning:
BPDU packets are received at the port
BPDU packets are ignored at the port
The BPDU receive status is enabled or disabled.
To Next Page
Loading...
Need help?
General
