Siemens SCALANCE W760 - Snmp Notify

Network protocols
7.4 SNMP
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
318 Configuration Manual, 11/2014, C79000-G8976-C351-03
7.4.2.12
snmp notify
Description
With this command, you configure the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp notify <NotifyName> tag <TagName> type {Trap|Inform}
[{volatile|nonvolatile}]]
The parameters have the following meaning:
Parameter
Description
Range of values / note
NotifyName
Name of the SNMP notification
max. 32 characters
tag
Keyword for a target key -
TagName
Name of the target key
max. 32 characters
Type
Type of the SNMP notification
•
Trap
generates a trap
• Inform
generates a log entry or sends
an entry to the log server
Storage type specifies whether the settings remain
following a restart:
•
volatile (volatile):
The settings are lost after a
restart
•
nonvolatile (non-volatile):
The settings are retained after
a restart
Result
The details of the SNMP notifications are configured.