Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
208 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
switchport acceptable-frame-type{all|tagged}
The parameters have the following meaning:
All frames (with and without VLAN variables) are accepted
Only frames with VLAN variables are accepted
At system start or when using the restart command with the option memoryor factory, the
following defaults apply:
● The function is configured for
all.
The setting is enabled.
You can display the status of this function and other information with the show vlan port
config
command.
switchport access vlan
Description
With this command, you assign an VLAN to an interface and configure the port VLAN
identifier (PVID) for it.
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Call up the command with the following parameters:
switchport access vlan <vlan-id(1-4094)>
The parameter has the following meaning:
Number of the addressed VLAN
To Next Page
Loading...
Need help?
General
