Siemens SCALANCE W760 Configuration Manual

Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
185
Syntax
Call up the command with the following parameters:
wlan roaming threshold { low | medium | high }
The parameters have the following meaning:
Parameter
Description
low
Even if the difference in field strength is low, change to the AP with the stronger
signal.
medium
If the difference in field strength is medium, change to the AP with the stronger
signal.
Default: medium
high
If the difference in field strength is high, change to the AP with the stronger sig-
nal.
Result
The threshold is specified.
Further notes
You display the setting with the show wlan client <wlan 0/X> command.
6.1.5.49
wlan rts-cts threshold
Description
With this command, you specify the packet size starting at which RTS/CTS (Request To
Send/Clear To Send) will be used.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan rts-cts threshold < bytes(1-2346)>
The parameter has the following meaning:
Parameters
Description
Values or range of values
bytes
Size specified in bytes 1...2346
Default: 2346

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English