Siemens SCALANCE W760 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
225
6.3.1.8
show spanning-tree mst interface
Description
This command shows port-specific settings of a Multiple Spanning Tree configuration.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst
[<instance-id(1-64)>] interface<interface-type><interface-id>
[{stats|hello-time|detail}]
The parameters have the following meaning:
Parameter
Description
Range of values
instance-id
Number of the instance or range of instances
whose settings are displayed
1 ... 64
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id
Module no. and port no. of the interface
stats
Shows the number of incoming and outgoing
packets for each path of the interface
-
hello-time
Shows the intervals at which the root switch
sends its "Hello" message to the other
switches
-
detail
Shows detailed information about the select-
ed interface
-
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
Result
The settings are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-tree
command.

Siemens SCALANCE W760 Specifications

General

Brand	Siemens
Model	SCALANCE W760
Category	Wireless Access Point
Language	English