Network structures
6.1 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
168 Configuration Manual, 11/2014, C79000-G8976-C351-03
With this command, you enable the "DFS(802.11h)" function. If the access point discovers a
disruption on the current channel, for example due to a radar device, it automatically
switches to an alternative channel.
● Frequency band 5 GHz is used.
In client mode, a mixed frequency band mode is possible (2.4 - 5 GHz).
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Call the command without parameter assignment:
wlan dfs
The DFS function is enabled.
You display the setting with the show wlan basic <wlan 0/X> command.
You disable the function with the
no wlan dfs command (default setting).
no wlan dfs (Page 169)
To Next Page
Loading...
Need help?
General
