Network structures
6.3 Spanning Tree
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
237
no spanning-tree mst max-hops
Description
With this command, you reset the maximum number of hops that a path in an MST can run
through to the default value.
The default value is 20.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no spanning-tree mst max-hops
The setting for the maximum number of nodes is reset to the default value.
You can configure the setting for the maximum number of nodes with the spanning-tree mst
max-hops
command.
You display this setting and other information with the
show spanning tree mst
configuration
command.
spanning-tree priority
Description
With this command, you configure the priority of the device. Which device becomes the root
bridge is decided based on the priority. The bridge with the highest priority becomes the root
bridge. The lower the value, the higher the priority.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
To Next Page
Loading...
Need help?
General
