Network protocols
7.3 DHCP server
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
290 Configuration Manual, 11/2014, C79000-G8976-C351-03
Call up the command with the following parameters:
lease-time <seconds (60-31536000)>
The parameter has the following meaning:
Time until renewal of the assigned
60 ... 31536000
The time is configured.
You display the setting with the show ip dhcp-server pools command.
Note
The command is only available with the following device:
SCALANCE W722-1 RJ-45 (MLFB 6GK5722-1FC00-0AA0 and 6GK5722-1FC00-0AB0
(US version))
With this command you configure the IPv4 address band from which the DHCP client
receives any IPv4 address.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
To Next Page
Loading...
