Siemens SCALANCE W760 - Show Events Smtp-Port; Commands in the Events Configuration Mode

Network protocols
7.5 SMTP client
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
331
Result
The configured e-mail sender address is displayed.
7.5.3
show events smtp-port
Description
This command shows the configured SNMP port.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events smtp port
Result
The configured SMTP port is displayed.
7.5.4
Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the
events command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
● If you exit the EVENTS configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the
end command, you return to the
Privileged EXEC mode.