Network structures
6.2 VLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 11/2014, C79000-G8976-C351-03
199
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
The parameters have the following meaning:
Keyword for a VLAN or VLAN range
Number of the addressed VLAN or VLAN range
Keyword for a MAC address
MAC address -
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 23)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
The entries are displayed.
This command shows the specific information for all or a selected VLAN.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General
