Siemens SCALANCE W760 - Wlan Security Dot1 X Check-Server-Certificate (Client)

Security and authentication
10.2 WLAN
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
378 Configuration Manual, 11/2014, C79000-G8976-C351-03
10.2.5.4
wlan security dot1x check-server-certificate (client)
Description
With this command, you enable the validation of the server certificate on the client.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan security dot1x check-server-certificate
Result
Validation is enabled.
Further notes
You display the settings with the show wlan security <wlan 0/X> command.
You disable the validity check with the
no wlan security dot1x check-server-certificate
command (default setting).
See also
no wlan security dot1x check-server-certificate (client) (Page 379)